This custom-made Pittsburgh Steelers " Men of Steel " art piece is made from a solid piece of STEEL crafted in the USA, not to mention, each piece is hand-polished. This is a collectible piece of art that every Yinzer should hang on the wall.
Size: 24 inches tall x 18 inches wide
Thickness: 7 gauge steel ( .180 )
Material: HRPO (Hot Rolled Pickled & Oiled) Sheet
Pre-drilled holes to mount into your wall studs - the standard width of wall studs is 16" and the holes line up for easy mounting
Made in the USA from STEEL that was forged in one of our mills.
Includes:
Mounting hardware
Accessories available:
LED Backlight kit with timer - additional $39
NOTE: AAA batteries not included. Lighting banks require 12 batteries and the remove requires 2 (Totally of 14 AAA batteries)
Installation Instructions:
Find a stud in the wall and then line up the two holes on the left so that they run vertical with the stud.
Check to make sure the sign looks level buy placing the level under the Men of Steel cutouts
Mark all 3 holes - the mounting hole on the right will line up with the adjacent stud since it is designed to be 16 inches on center from the holes on the left.
You can create small pilot holes if you want because it make the install easier plus you can double check that all three line up with the studs
Then you just screw in the lag bolts with the spacers and washers
If you have any problems, you can contact us and we'll personally walk you through the steps and will video conference with you to help in the perfect installation.
Installation Video:
-----------
Make it even better buy adding your own lighting kit:
We recommend the following Lighting kit and you can buy it on Amazon:
This custom-made "The Standard is the Standard" Pittsburgh Steelers 11 gauge steel Wall Art Piece is made from a solid piece of STEEL crafted in the USA, not to mention, each piece is hand-polished. This is a collectible piece of art that every Yinzer should hang on the wall.
Thickness: 11 gauge steel ( .116" )
Material: HRPO (Hot Rolled Pickled & Oiled) Sheet
Pre-drilled holes to mount into your wall studs - the standard width of wall studs is 16" and the holes line up for easy mounting
Size is: 24" wide x 12" high
Made in the USA from STEEL that was forged in one of our mills.
Includes:
Mounting hardware
Installation Instructions:
Find a stud in the wall and then line up the two holes on the left so that they run vertical with the stud.
Check to make sure the sign looks level buy placing the level under the Standard is the Standard letter cutouts
Mark all 4 holes - the mounting hole on the right will line up with the adjacent stud since it is designed to be 16 inches on center from the holes on the left.
You can create small pilot holes if you want because it make the install easier plus you can double check that all three line up with the studs
Then you just screw in the lag bolts with the spacers and washers.
Note:
If you have any problems, you can contact us and we'll personally walk you through the steps and will video conference with you to help in the perfect installation.
Installation Video:
-----------
Make it even better buy adding your own lighting kit:
We recommend the following Lighting kit and you can buy it on Amazon:
